- A torque wrench
- Alen keys
- Spring compressor OP 3231: Spring compressor for "MCPHERSON" type 3T struts
- A shock absorber head removal spanner OM 1112 : Set of 18 special tools for mounting and removing shock absorber heads
- A knuckle spacer tool OM9272: Spacer tool for struts or wheel wishbones
Disassemble and fitting a suspension strut top kit
How to correctly install a suspension strut top kit (KB) when changing a shock absorber strut on the vehicle
- 1
- 2
Remove the wheel on the relevant side.
- 3
Undo the stabiliser bar.
- 4
Disconnect the brake hose from the shock absorber strut n order to reposition correctly, place a mark to facilitate reassembly).
- 5
Undo the shock absorber stabiliser bar linkage.
- 6
Loosen the steering knuckle nut.
- 7
Loosen the nut securing the shock absorber rod to the yoke and remove the shock absorber.
- 8
Position the shock absorber in the spring compressor.
- 9
Compress the spring.
- 10
Remove the suspension stop and change the shock absorber.
When changing the shock absorber, also remember to change the suspension stops.
- 11
Reinstall the new suspension stop kit.
Check the shock absorber boot seal and replace it if defective.
- 12
Release the spring.
Pay attention to the direction of Reassembly of the parts.
- 13
Refit the parts (in the reverse order to removal), observing the tightening torques.
